600-601 Free Practice Test

Exhibit:
<>

1. A. The EtherNet/IP drive connections are in a high-voltage area and need protection from electromagnetic noise, so shielded cable that is rated for 600 V is advised.
2. B. EtherNet/IP devices such as the controller, drive, VoIP phone, and IP camera should be in the sameVLAN.
3. C. CIP traffic has the highest bandwidth requirement so it needs the highest QoS setting.
4. D. EtherNet/IP drive traffic has high sensitivity to random drops, latency, and jitter.
5. E. Real-time motion control and VoIP traffic can share the same VLAN with the proper QoS setting.
6. F. IEEE1588 and PTP are important for ensuring real-time synchronization.

Correct Answer: ADF

An administrator has connected devices to an industrial switch and, for security reasons, wants the dynamically learned MAC addresses from the address table added to the running configuration. What must be done to accomplish this?

1. A. Enable port security and use the keyword sticky.
2. B. Set the switchport mode to trunk and save the running configuration.
3. C. Use the switchport protected command to have the MAC addresses added to the configuration.
4. D. Use the no switchport port-security command to allow MAC addresses to be added to the configuration.

Correct Answer: A

Given a ring topology, which loop prevention mechanism provides the fastest reconvergence time after a link failure?

1. A. Rapid Per-VLAN Spanning Tree Protocol
2. B. Resilient Ethernet Protocol
3. C. Multiple Spanning Tree Protocol
4. D. Spanning Tree Protocol

Correct Answer: B

Which option allows an EtherNet/IP I/O device to be safely installed where it is subject to water immersion?

1. A. The device is rated IP20 and the power wiring is installed securely to the terminal block.
2. B. The device is rated IP67 and a power cordset is used.
3. C. The device is rated IP67 and immersed to 10 m.
4. D. The device is rated IP20 and immersed to 10 m.

Correct Answer: B

You are troubleshooting a connectivity problem and want to isolate the problem. You suspect that a router on the route to an unreachable network is at fault. Which command would you issue to see where the packets stop?

1. A. router#ping
2. B. router#tracert
3. C. router#show ip route
4. D. router#show cdp neighbors
5. E. router#traceroute

Correct Answer: E