350-501 Free Practice Test

Which statement about TLS is accurate when using RESTCONF to write configurations on network devices'?

1. A. It requires certificates for authentication.
2. B. It is provided using NGINX acting as a proxy web server
3. C. It is used for HTTP and HTTPS requests.
4. D. It is not supported on Cisco devices

Correct Answer: A

Refer to the exhibit.

An engineer is configuring path selection on router R1 for two ASNs as shown. Which additional task must the engineer perform on Router 1 so that all outbound traffic utilizes the link between R1 and R3 to reach ASN 4567?

1. A. Configure a low weigh! on the peer to ASN 4567.
2. B. Configure a high weight on the peer to ASN 4567.
3. C. Configure an AS path prepend on the peer to ASN 4567.
4. D. Configure a high med on the peer to ASN 4567.

Correct Answer: B

What is the role of NSO?

1. A. Provides public cloud services for customers that need Internet access.
2. B. Controls the turn-up of a device.
3. C. Provides network monitoring services for Layer 3 devices.
4. D. Maintains data storage.

Correct Answer: B

Refer to the exhibit.

A network engineer must deny access from spoofed addresses to the LAN. The edge router currently has two active BGP sessions established with Tier 1 ISP_A. Due to asymmetric routing, no ACL is configured on either interface. Which two configurations must the engineer perform on the edge router to complete the task? (Choose two.)

1. A. ip verify unicast source reachable-via tx under FA0/0
2. B. ip verify unicast source reachable-via under FA0/1
3. C. ip verify unicast source reachable-via any under FA0/1
4. D. ip verify unicast source reachable-via both under FA0/0
5. E. ip verify unicast source reachable-via any under FA0/0

Correct Answer: CE

After implement MPLS protocol for multiple VRFs on a single Cisco device, the engineer notices all VRFs on the router still do to not LDP session protection feature enabled. Which configuration must the engineer apply to enable the LDP session protection feature FOR LDP neighbors within each VRF?

1. A. Configure LDP session protection globally on the device only.
2. B. Configure LDP session protection globally on the device and on each neighbor that requires session protection.
3. C. Configure LDP session authentication on the device to enable LDP session protection on each VRF automatically.
4. D. Configure LDP session protection within the individual VRFs.

Correct Answer: D