350-401 Free Practice Test

- (Exam Topic 4)
Drag and drop the snippets onto the blanks within the code to create an EEM script that adds an entry to a locally stored text file with a timestamp when a configuration change is made. Not all options are used.

Solution:


Does this meet the goal?

1. A. Yes
2. B. No

Correct Answer: A

- (Exam Topic 2)
Refer to the exhibit.

After the code is run on a Cisco IOS-XE router, the response code is 204. What is the result of the script?

1. A. The configuration fails because another interface is already configured with IP address 10.10.10.1/24.
2. B. The configuration fails because interface GigabitEthernet2 is missing on the target device.
3. C. The configuration is successfully sent to the device in cleartext.
4. D. Interface GigabitEthernet2 is configured with IP address 10.10.10.1/24

Correct Answer: D

- (Exam Topic 2)
An engineer must create an EEM script to enable OSPF debugging in the event the OSPF neighborship goes down. Which script must the engineer apply?

1. A. Option A
2. B. Option B
3. C. Option C
4. D. Option D

Correct Answer: C

- (Exam Topic 3)

Refer to the exhibit. A network engineer checks connectivity between two routers. The engineer can ping the remote endpoint but cannot see an ARP entry. Why is there no ARP entry?

1. A. The ping command must be executed in the global routing table.
2. B. Interface FastEthernet0/0 Is configured in VRF CUST-A, so the ARP entry is also in that VRF.
3. C. When VRFs are use
4. D. ARP protocol must be enabled In each VRF.
5. E. When VRFs are use
6. F. ARP protocol is disabled in the global routing table.

Correct Answer: B

- (Exam Topic 1)
What is the difference between CEF and process switching?

1. A. CEF processes packets that are too complex for process switching to manage.
2. B. CEF is more CPU-intensive than process switching.
3. C. CEF uses the FIB and the adjacency table to make forwarding decisions, whereas process switching punts each packet.
4. D. Process switching is faster than CEF.

Correct Answer: C