2V0-41.20 Free Practice Test

Which two BGP configuration parameters can be configured in the VRF Lite gateways? (Choose two.)

1. A. Route Aggregation
2. B. Route Distribution
3. C. Graceful Restart
4. D. BGP Neighbors
5. E. Local AS

Correct Answer: AD
The following parameters are inherited from the default Tier-0 gateway and cannot be modified at the VRF level:
• Local AS
• Graceful restart
• Graceful restart timer
• Graceful restart stale timer
• Multipath relax
Inter-SR iBGP is not supported in VRF gateways. BGP can be enabled or disabled per VRF gateway.
Route aggregation and BGP neighbors are local configurations per VRF.

Which statement is true about an alarm in a Suppressed state?

1. A. An alarm can be suppressed for a specific duration in days.
2. B. An alarm can be suppressed for a specific duration in minutes.
3. C. An alarm can be suppressed for a specific duration in seconds.
4. D. An alarm can be suppressed for a specific duration in hours.

Correct Answer: D
https://docs.vmware.com/en/VMware-NSX-Intelligence/1.1/user-guide/GUID-EBD3C5A8-F9AB-4A22-BA40- "If you move an alarm into a Suppressed state, you are prompted to specify the duration in hours. After the specified duration passes, the alarm state reverts to Open. However, if the system determines the condition has been corrected, the alarm state changes to Resolved."
https://docs.vmware.com/en/VMware-NSX-T-Data-Center/3.0/administration/GUID-EB1BB1D3-8892-4890-B

In a NSX-T Data Center environment, an administrator is observing low throughput and congestion between the Tier-0 Gateway and the upstream physical routers.
Which two actions could address low throughput and congestion? (Choose two.)

1. A. Deploy Large size Edge node/s.
2. B. Configure ECMP on the Tier-0 gateway.
3. C. Configure NAT on the Tier-0 gateway.
4. D. Add an additional vNIC to the NSX Edge node.
5. E. Configure a Tier-1 gateway and connect it directly to the physical routers.

Correct Answer: AB

Which three functions require a Services Router (SR) component on an Edge node? (Choose three.)

1. A. Service Insertion
2. B. Distributed Routing
3. C. Packet Forwarding
4. D. Gateway Firewall
5. E. Distributed Firewall
6. F. Virtual Private Network

Correct Answer: ADF

A customer has a network where BGP has been enabled and the BGP neighbor is configured on the Tier-0 Gateway. A NSX-T Data Center administrator used the get logical-routers command to retrieve this information:

Which two commands must be executed to check BGP neighbor status? (Choose two.)

1. A. vrf 3
2. B. vrf 1
3. C. vrf 4
4. D. sa-nsxedge-01(tier1_sr)> get bgp neighbor
5. E. sa-nsxedge-01(tier0_sr)> get bgp neighbor
6. F. sa-nsxedge-01(tier0_dr)> get bgp neighbor

Correct Answer: AE