- (Exam Topic 1)
When simulating a problem on CLusterXL cluster with cphaprob –d STOP –s problem –t 0 register, to initiate a failover on an active cluster member, what command allows you remove the problematic state?
Correct Answer:
A
esting a failover in a controlled manner using following command;
# cphaprob -d STOP -s problem -t 0 register
This will register a problem state on the cluster member this was entered on;If you then run;
# cphaprob list
this will show an entry named STOP.
to remove this problematic register run following;
# cphaprob -d STOP unregister References:
- (Exam Topic 2)
You are a Security Administrator who has installed Security Gateway R80 on your network. You need to allow a specific IP address range for a partner site to access your intranet Web server. To limit the partner’s access for HTTP and FTP only, you did the following:
1) Created manual Static NAT rules for the Web server.
2) Cleared the following settings in the Global Properties > Network Address Translation screen:
- Allow bi-directional NAT
- Translate destination on client side
Do the above settings limit the partner’s access?
Correct Answer:
D
- (Exam Topic 1)
Which one of these is NOT a firewall chain?
Correct Answer:
B
- (Exam Topic 1)
What can you do to see the current number of kernel instances in a system with CoreXL enabled?
Correct Answer:
D
- (Exam Topic 3)
You want VPN traffic to match packets from internal interfaces. You also want the traffic to exit the Security Gateway bound for all site-to-site VPN Communities, including Remote Access Communities. How should you configure the VPN match rule?
Correct Answer:
A