JN0-452 Free Practice Test

You are the only tenant in a building that has Wi-Fi. At times, the Wi-Fi network appears to be slow and you want to determine if the microwave oven is causing an issue because it is used throughput the day. Which SLE metric and classifier should you look at to determine the issue?

1. A. throughput/network issues
2. B. capacity/wifi interference
3. C. throughput/coverage
4. D. capacity/non-wifi interference

Correct Answer: D

Which two statements correctly describe the Wi-Fi location component of Juniper Mist??s location-based services? (Choose two.)

1. A. It tracks third-party BLE tags.
2. B. It is included in the Wireless Assurance subscription.
3. C. It is enabled by default.
4. D. It requires the Asset Visibility subscription.

Correct Answer: BD

Which access points (APs) will be considered for inclusion in the AP Offline Marvis Action?

1. A. all APs assigned to sites that have connected to the cloud previously
2. B. all APs assigned to sites
3. C. all APs in inventory
4. D. all purchased APs

Correct Answer: A

Site A is configured with a WLAN and a policy. The administrator creates a configuration template at the organization level with additional policies for the same WLAN and mentions Site A in this template.
In this scenario, which statement is correct?

1. A. The policy that is created in the config template at the organization level will execute first.
2. B. The policy created at the organization level can be applied to a site group, not to an individual site.
3. C. The policy that is created at the site level will execute first.
4. D. There is no option to mention the site in the config template at the organization level.

Correct Answer: D
According to the Juniper Mist Wireless Deployment Service Datasheet1, a configuration template at the organization level can be applied to a site group, not to an individual site. Therefore, there is no option to mention the site in the config template at the organization level.
[References: https://www.juniper.net/us/en/products/cloud-services/juniper-mist-wireless-deployment-service-datasheet.html, , ]

Asset tracking using Mist-supported third-party BLE beacons has been installed in a warehouse. The BLE beacons were configured using their manufacturer-supplied configuration utility and BLE was properly configured for the site settings. When the warehouse floor plan is opened in Live View, the third-party beacons are not shown.
Which two statements describe causes for this issue? (Choose two.)

1. A. The Show assets check box has not been selected in Live View.
2. B. Marvis was not enabled for the site.
3. C. The Locate this Client as an Asset check box has not been selected at the BLE client level.
4. D. The APs are installed at 19 feet from the floor, above the recommended 15 feet.

Correct Answer: AC